OEM PP PU Material Filter Element Material Round Square Air Filters
1. Product introduction
Air filter is widely used in many kinds of automobile and
engineering equipment. In order to work smoothly, all machines need
to replace the filter.
To make the filter, Pu mold is inevitable. High quality Pu mold can
be reused up to 80 times, greatly reducing the cost of the filter.
Pu mold is made of plastic PP material. Our company purchases
high-quality raw materials to meet the quality requirements of
customers at home and abroad.
2. Parameter table
235,235B,235C 769,769B,768C Loader
3. Product use
It is used in the production of all air filters and oil diesel
However, the air filter element is particularly important. Some
large dust particles or paper scraps outside the car need to be
filtered by the air filter element. The air flow sensor is
responsible for the regulation of sending air into the next link.
The throttle is to control the intake flow, and the accelerator
pedal is directly controlled. Finally, a mixture of air and
gasoline is synthesized for combustion in the engine.
We are manufacturer
With 15 years of production experience
Long working life.
Good anti-humidity performance
Special size available as you request
Sample offered as request
5. Production process
1. Material-A should stirred evenly with plastic hand electric
drill, material-B can shake, before used.
2. Open the electrocaloric plate temperature to 40-50 degrees, in
winter material-A and material-B with a small container to preheat.
3. Wipe the mould with release agent
the air, workshop environment.
5. material-A and material-B are mixed at the mixture ratio of
100:40 ratio, then add 40% talcum powder(heavy calcium
powder)(100:40:50±5), with 2800 rev / min motor to mix, mixing time
determined by the amount of adhesive, per 100g of adhesive is
approximately 7-10 seconds .
6. Pour the Mixed liquid into mould, then put the paper element and
give a little pressure on it. 8-15 minutes later you can bring the